<div class="airmaster"> Airmasters Energy Saving Air Curtain also known as “Air Knives” provides an efficient laminar sheet of air for wide area cleaning and drying applications. Since Air Knives are a type of air amplifiers, they use a small amount of compressed air to deliver a powerful, high velocity, laminar sheet of air over wide areas such as moving webs, film, sheets, strips, auto bodies and other large assemblies and objects. Airmasters Air Knives are the perfect replacements for drilled or slotted lengths of pipe. In addition, the Air Knives offers up to 70% compressed air savings when compared to the drilled pipes. Stainless Steel models are ideal for food, pharmaceutical, chemical and other applications where purity, high temperatures or corrosive environments are concerned. Airmaster Air Knives increase thrust and velocity, reduced noise, excellent uniformity, and significantly outperforms any competing, wide blowoff device. <h5>Use of Shims</h5> Airmaster uses ONLY stainless steel shims in their Air Knife products as plastic shims wear out over time and require replacement, even with relatively clean air systems. Stainless steel shims are .002” (.050 mm). In most application this is adequate. However, velocity and force can be increased approximately 30% by adding a second .002” (.050 mm) shim. Shims may be stacked up to 5 sets. If using three or more sets however, the air inlets at the “ends” should be used to maintain even flow along the Air Knife system. Otherwise a slight d op in pressure and flow will occur across from the rear inlet ports if they are usedwith three or more shims Note that noise levels and air use will go up with an increased number of shims. </div> <div class="trial-btn"><a class="trigger" href="https://www.agency09.co/staging/aceflow/wp-content/uploads/2024/02/AIR-KNIFE.pdf" type="button">Download Brochure</a></div>

<div class="airmaster"> The AIR FLOW VAC Compressed Air Conveying System utilizes compressed air for a powerful, efficient venturi action along its length in a compact design for high capacity conveying over large distances. Available in both coated aluminium or high temperature stainless steel.Simply clamp a standard hose size to each end of the AIR FLOW VAC or AIR CONVEYOR to create this high energy conveying system. No moving parts for maintenance free operation with capacity and flow controlled with a pressure regulator. The AIR FLOW VAC or AIR CONVEYOR System is available in 3/8” (9.5 mm), 1/2” (12.7mm), 3/4” (19 mm), 1" (25mm), 1-1/4" (32mm), 1-1/2" (38mm), 2" (51mm), 2-1/2" (64mm), 3" (76mm), 4“ (101.6mm) and 5“ (127 mm) sizes Any size beyond that can be prohibitive for most applications due to high compressed air requirements. In addition, beyond 5", the vacuum ability begins to drop significantly except for highly intermittent applications. For applications beyond 3", a blower system often becomes far more economical except in a rare number of possible applications. </div> <div class="trial-btn"><a class="trigger" href="https://www.agency09.co/staging/aceflow/wp-content/uploads/2024/02/AIR_FLOW_VAC_AIR_CONVEYOR.pdf" type="button">Download Brochure</a></div>